StorCase Technology DX100-SNC

Filesize: 150.29 KiB, Pages: 2, Added: 2020-07-29 15:38:23

User Rating

StorCase Technology DX100-SNC
D89-0000-0069 - Rev. A00 Kingston Technology Company
SINGLE-CONNECT ADAPTER BOARD
This document provides detailed information to support Kingston's Single-Connect Adapter Board (Part #s: DX100-
SNC and DX100-SWC). This adapter allows the connection between either a standard 50-pin 8-bit SCSI or a 68-pin
Wide 16-bit SCSI cable connector, and a storage device which has a Single-Connect (80-pin) type interface connec-
tor. The DX100-SWC also supports Ultra 2 SCSI (Low Voltage Differential (LVD) and Single-Ended) interfaces.
The Single-Connect Adapter Board provides a standard 4-pin Molex Power connector, and several jumper options as
described below. For information regarding jumper setting requirements for the specific storage device, please refer
to the device manufacturer's documentation.
Figure 1- Single-Connect Configuration (8-bit version shown)
Figure 2 - Single-Connect Adapter Board
(16-bit shown; 8-bit connector is Male)
Jumpers on the Single-Connect Adapter Board are factory-installed on the Enable Termination Power (TPR) pins, and
on all of the SCSI ID Select (ID0-ID3) pins. These jumpers may be reconfigured as required. Refer to the following
information for pin descriptions.
(over)
This manual is related to the following products:
StorCase Technology DX100-SNC

© 2020 Instructions and manuals Brands | Privacy Policy | Terms of Service | Feedback